Help Contact

In order to serve you better, this website makes use of Cookies. By clicking "I agree" or by continuing to use this website, you agree to the placing of these cookies.



Bandpass section

Configures filters to remove very low (bass) or very high frequencies.

Bandpass panel


General panel

General Bandpass filter settings.

  • Bandpass filter
    Turns bandpass filtering on or off.

Highpass panel

Highpass (removes bass) settings.

More highpass settings panel


  • Highpass filter
    Remove very deep bass sounds.

    Controls the highpass frequency. Tones below this frequency are removed.

    The behavior of the highpass filter is affected by the setting of Phase linear highpass filter.

  • Phase linear highpass filter
    Determines whether highpass filtering is done phase linear (with artifacts), or non-phase linear (without artifacts).

    Phase linear means that the shape of the bass is not changed (except that low frequencies are removed). This causes some artifacts (chopper like sounds), especially at lower latency or quality settings.

    Non-phase linear means that the shape of the bass is allowed to change. It will still sound the same, but the locations of peaks in the signal will move.

    Possible settings:
    • Automatic selection
    • Phase linear at latencies 2048 and 4096 samples, non-phase linear at latencies 512 and 1024 samples.
    • Always phase linear
    • Never phase linear
    An additional advantage of non-phase linear filtering is that it moves different bass frequencies around in time. This is not or hardly noticeable, but it does offer an advantage to the Advanced Clipper filter for short bass spikes: Because the bass is spread over time, Loudness can boost it further, resulting in louder bass levels without affecting the rest of the sound.

  • Highpass filter order (non-phase linear)
    The order of the highpass filter.

    A higher value means steeper filtering. This can in some cases lead to unnatural sounding bass.

  • Legacy filter

  • Act as if highpass is at start (if in phase linear mode)

  • Pre-process offset to reduce artifacts

  • Pre-process offset to reduce AGC artifacts

  • Post filter to avoid DC offset
    Extra filter later in the chain to remove any newly added DC offset.

  • Reduce post filter artifacts
    Filters the post filter output to remove some artifacts caused by filtering.

Lowpass panel

Settings that control removal of high frequencies.

More lowpass settings panel


  • Lowpass filter
    Remove high frequencies.

    Controls the lowpass frequency. Tones above this frequency are removed.

    This filter is very steep. The volume starts to drop a few hundred Hz below the configured frequency, and no frequencies above the set frequency should be coming through. The lowpass filter is always phase linear.

    Some special values are:
    • 15000
      This is the lowpass frequency that should officially be used for FM stations. Since the filter is very steep, slightly higher frequencies should also work, and result in a better output quality.
    • 4500 Hz
    • The lowpass frequency for AM stations in Europe.


  • Filter before processing (never below 16 kHz)
    Filters out some high frequencies to protect processing against audio problems.

    Some tracks from around 2010-2013 have a high pitched tone in them, which causes compressors (not just in Stereo Tool but in nearly all audio processors) to go haywire. If this setting is enabled, such frequencies are filtered out before processing starts, which solves the problem.